0
RESEARCH PAPERS

Surface Finishes Produced by Tungsten Carbide Taper Pin Reamers

[+] Author and Article Information
D. M. Turley

Australian Defence Scientific Service, Department of Supply, Defence Standards Laboratories, Melbourne, Australia

J. Eng. Mater. Technol 97(1), 21-24 (Jan 01, 1975) (4 pages) doi:10.1115/1.3443255 History: Revised August 14, 1973; Online August 17, 2010

Abstract

The surface finishes produced by taper reaming of holes in a composite structure of aluminum alloy and ultra-high strength steel are examined for both dry and lubricated cutting conditions. In dry reaming cutting occurred under built-up-edge (BUE) conditions whereas when a mineral cutting oil was used no significant BUE was formed. Reaming under the latter conditions resulted in a more undulating steel surface finish but a much smoother surface finish for the aluminum alloy.

Copyright © 1975 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In