0
RESEARCH PAPERS

Formability of Aluminum Alloy Sheets

[+] Author and Article Information
S. S. Hecker

Research Labs, General Motors Corp., Warren, Mich.; Los Alamos Scientific Laboratory, Los Alamos, N. M.

J. Eng. Mater. Technol 97(1), 66-73 (Jan 01, 1975) (8 pages) doi:10.1115/1.3443263 History: Revised December 04, 1973; Online August 17, 2010

Abstract

High strength-to-weight ratio materials are becoming of increasing importance in the automotive industry. Some aluminum alloy sheets offer strength equivalent to low-carbon sheet steel at one third of the weight. However, for these alloys no production stamping experience exists and little meaningful laboratory data have been accumulated. This study was conducted to provide such laboratory information. Complete tensile properties and forming limit curves (FLC), as measured by a laboratory technique developed by the author, were determined for the aluminum alloys with a wide range of properties and were compared to the properties of low-carbon steel. All the aluminum alloys were found to have lower FLC’s, lower r values and equal or lower strain hardening capacities than sheet steel. Therefore their formabilities will be less than those of steel for all modes of sheet forming. This predicted press performance was verified for some of these alloys in limited press trials on a deck lid (inner panel) stamping.

Copyright © 1975 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In