0
RESEARCH PAPERS

Benchmark Cyclic Plastic Notch Strain Measurements

[+] Author and Article Information
William N. Sharpe, Michael Ward

Mechanical Engineering Department, Louisiana State University, Baton Rouge, 70803

J. Eng. Mater. Technol 105(4), 235-241 (Oct 01, 1983) (7 pages) doi:10.1115/1.3225652 History: Received December 03, 1982; Online September 23, 2009

Abstract

Plastic strains at the roots of notched specimens of Inconel 718 subjected to tension-compression cycling at 650°C are reported. These strains were measured with a laser-based technique over a gage length of 0.1 mm and are intended to serve as “benchmark” data for further development of experimental, analytical, and computational approaches. The specimens were 250 mm by 2.5 mm in the test section with double notches of 4.9 mm radius subjected to axial loading sufficient to cause yielding at the notch root on the tensile portion of the first cycle. The tests were run for 1000 cycles at 10 cpm or until cracks initiated at the notch root. The experimental techniques are described, and then representative data for the various load spectra are presented. All the data for each cycle of every test are available on floppy disks from NASA.

Copyright © 1983 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In