0
RESEARCH PAPERS

Redundant Deformation Factor Evaluation Through the Stress-Strain Curves Superposition Method in Round Section Bar Drawing—Experimental Results

[+] Author and Article Information
P. R. Cetlin, J. L. N. Marcos

Department of Metallurgical Engineering, Universidade Federal de Minas Gerais, 30.000, Belo Horizonte, MG, Brazil

J. Eng. Mater. Technol 109(4), 276-281 (Oct 01, 1987) (6 pages) doi:10.1115/1.3225977 History: Received May 01, 1987; Online September 15, 2009

Abstract

Based on a previous literature analysis of the stress-strain curves superposition method for the evaluation of the redundant deformation factor φ, an experimental program is proposed and carried out for SAE 1018 steel. The method is applied for tensile and compressive testing, and for multiple and single passes up to 30 percent logarithmic strains. For single passes, results for tensile testing were reasonably in accordance with those in the literature. For multiple passes, work hardening was higher for 2 or 3 passes than for 1 pass, contrarily to results for Copper in the literature. Compression testing should not be used for φ evaluation if one wants to obtain φ values similar to those in the literature.

Copyright © 1987 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In