0
RESEARCH PAPERS

Simulation of Slump in Plastic Pipe Extrusion

[+] Author and Article Information
D. N. Githuku, A. J. Giacomin

Mechanical Engineering Department, Texas A&M University, College Station, TX 77843-3123

J. Eng. Mater. Technol 114(1), 81-83 (Jan 01, 1992) (3 pages) doi:10.1115/1.2904145 History: Received August 02, 1990; Revised June 16, 1991; Online April 29, 2008

Abstract

Extruded plastic pipe leaving an annular die is solidified in a long cooling tank by spraying the outer surface with cold water. The inside surface can take a long time to solidify as the solidification progresses radially inward. This results in flow of molten polymer down the inside of the pipe. This gravity flow of molten extrudate is called slumping, and it can cause serious nonuniformity in pipe wall thickness particularly in large diameter, thick walled pipes. It can also lead to another phenomenon known as “knuckle” formation where melt accumulates at specific locations. A simple numerical scheme to model this flow has been developed. Three-dimensional graphical illustrations of the slumping phenomenon based on this simulation are presented in this paper. The model predictions have been compared with commerical pipe data and they are in qualitative agreement.

Copyright © 1992 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In