Estimation of Cutting Temperature in High Speed Machining

[+] Author and Article Information
Jehnming Lin, Shinn-Liang Lee, Cheng-I Weng

Department of Mechanical Engineering, National Cheng Kung University, Tainan, Taiwan 70101, Republic of China

J. Eng. Mater. Technol 114(3), 289-296 (Jul 01, 1992) (8 pages) doi:10.1115/1.2904175 History: Received October 22, 1991; Revised February 12, 1992; Online April 29, 2008


This paper presents a study of the inverse heat conduction problem for high speed machining. A finite element method with an inverse scheme and an experimental measurement using infrared (IR) pyrometer with fiber optic are applied to predict the tool-chip interface temperature and the total heat dissipating to both tungsten carbide and ceramic inserts. A one-dimensional ellipsoidal mapping model of the cutting temperature distribution is adopted here and the average transient cutting temperature is calculated by the inverse finite element method with measured surface temperatures adjacent to the tool edge. Also the analysis of the errors coming from the sensor location and mapping model is studied. The results show the estimated cutting temperature is well convergent and agrees to other previous investigations. It is found that the thermal conductivity of the tool material has significant effect on the heat dissipation but little effect on the tool-chip interface temperature in high speed machining.

Copyright © 1992 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.





Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In