Component-Mode-Based Reduced Order Modeling Techniques for Mistuned Bladed Disks—Part II: Application

In this paper, the component-mode-based methods formulated in the companion paper (Part I: Theoretical Models) are applied to the dynamic analysis of two example finite element models of bladed disks. Free and forced responses for both tuned and mistuned rotors are considered. Comprehensive comparisons are made among the techniques using full system finite element solutions as a benchmark. The accurate capture of eigenfrequency veering regions is of critical importance for obtaining high-fidelity predictions of the rotor’s sensitivity to mistuning. Therefore, particular attention is devoted to this subject. It is shown that the Craig–Bampton component mode synthesis (CMS) technique is robust and yields highly reliable results. However, this is achieved at considerable computational cost due to the retained component interface degrees of freedom. It is demonstrated that this problem is alleviated by a secondary modal analysis reduction technique (SMART). In addition, a non-CMS mistuning projection method is considered. Although this method is elegant and accurate, it is seen that it lacks the versatility and efficiency of the CMS-based SMART. Overall, this work shows that significant improvements on the accuracy and efficiency of current reduced order modeling methods are possible.