The evaluation of the performance and characteristics of a solar flat-plate collector (FPC) are reported for domestic and industrial requirements in the existing literature. A computer code was developed using matlab to model and evaluate the energetic and exergetic performance of a nanofluid-based FPC for steady-state and laminar conditions. The analysis was performed using practical geometry data, especially the absorber emittance, for a standard collector. Linear pressure losses in manifolds were taken into account, and a more accurate exergy factor corresponding to a correct value of 5770 K for the sun temperature was employed. The results demonstrate that copper–water nanofluid has the potential to augment the internal convection heat transfer coefficient by 76.5%, and to enhance the energetic efficiency of the collector from 70.3% to 72.1% at 4% volume concentration, when compared to the values with water. Additionally, it was revealed that copper nanofluid is capable of increasing the collector fluid's outlet temperature and decreasing the absorber plate's mean temperature by 3 K. The addition of nanoparticles to the water demonstrated a reduction in the total entropy generation by the solar FPC. Furthermore, increasing the nanoparticle size reflected a reduction in the overall performance of the solar collector.
Skip Nav Destination
Article navigation
June 2018
Research-Article
Energetic and Exergetic Performance of a Solar Flat-Plate Collector Working With Cu Nanofluid
SeyedReza Shamshirgaran,
SeyedReza Shamshirgaran
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia;
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia;
Department of Mechanical and
Energy Engineering,
Shahid Beheshti University,
Tehran 16765-1719, Iran
e-mail: seyedreza_g03458@utp.edu.my
Energy Engineering,
Shahid Beheshti University,
Tehran 16765-1719, Iran
e-mail: seyedreza_g03458@utp.edu.my
Search for other works by this author on:
Morteza Khalaji Assadi,
Morteza Khalaji Assadi
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: morteza.assadi@utp.edu.my
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: morteza.assadi@utp.edu.my
Search for other works by this author on:
Hussain H. Al-Kayiem,
Hussain H. Al-Kayiem
Mem. ASME
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: hussain_kayiem@utp.edu.my
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: hussain_kayiem@utp.edu.my
Search for other works by this author on:
Korada Viswanatha Sharma
Korada Viswanatha Sharma
Centre for Energy Studies,
Department of Mechanical Engineering,
JNTUH College of Engineering,
Kukatpally, Hyderabad 500085, India
e-mail: kvsharmajntu@gmail.com
Department of Mechanical Engineering,
JNTUH College of Engineering,
Kukatpally, Hyderabad 500085, India
e-mail: kvsharmajntu@gmail.com
Search for other works by this author on:
SeyedReza Shamshirgaran
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia;
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia;
Department of Mechanical and
Energy Engineering,
Shahid Beheshti University,
Tehran 16765-1719, Iran
e-mail: seyedreza_g03458@utp.edu.my
Energy Engineering,
Shahid Beheshti University,
Tehran 16765-1719, Iran
e-mail: seyedreza_g03458@utp.edu.my
Morteza Khalaji Assadi
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: morteza.assadi@utp.edu.my
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: morteza.assadi@utp.edu.my
Hussain H. Al-Kayiem
Mem. ASME
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: hussain_kayiem@utp.edu.my
Department of Mechanical Engineering,
Universiti Teknologi PETRONAS,
Bandar Seri Iskandar 32610,
Perak, Malaysia
e-mail: hussain_kayiem@utp.edu.my
Korada Viswanatha Sharma
Centre for Energy Studies,
Department of Mechanical Engineering,
JNTUH College of Engineering,
Kukatpally, Hyderabad 500085, India
e-mail: kvsharmajntu@gmail.com
Department of Mechanical Engineering,
JNTUH College of Engineering,
Kukatpally, Hyderabad 500085, India
e-mail: kvsharmajntu@gmail.com
1Corresponding author.
Contributed by the Solar Energy Division of ASME for publication in the JOURNAL OF SOLAR ENERGY ENGINEERING: INCLUDING WIND ENERGY AND BUILDING ENERGY CONSERVATION. Manuscript received August 4, 2017; final manuscript received November 27, 2017; published online February 20, 2018. Assoc. Editor: Gerardo Diaz.
J. Sol. Energy Eng. Jun 2018, 140(3): 031002 (8 pages)
Published Online: February 20, 2018
Article history
Received:
August 4, 2017
Revised:
November 27, 2017
Citation
Shamshirgaran, S., Khalaji Assadi, M., Al-Kayiem, H. H., and Viswanatha Sharma, K. (February 20, 2018). "Energetic and Exergetic Performance of a Solar Flat-Plate Collector Working With Cu Nanofluid." ASME. J. Sol. Energy Eng. June 2018; 140(3): 031002. https://doi.org/10.1115/1.4039018
Download citation file:
Get Email Alerts
Analysis of Erosion of Surfaces in Falling Particle Concentrating Solar Power
J. Sol. Energy Eng (April 2025)
Related Articles
Numerical Study on Conjugated Laminar Mixed Convection of Alumina/Water Nanofluid Flow, Heat Transfer, and Entropy Generation Within a Tube-on-Sheet Flat Plate Solar Collector
J. Sol. Energy Eng (August,2017)
Energy and Exergy Analysis of Marquise Shaped Channel Flat Plate Solar Collector Using Al 2 O 3 –Water Nanofluid and Water
J. Sol. Energy Eng (August,2019)
Predicted Efficiency of a Low-Temperature Nanofluid-Based Direct Absorption Solar Collector
J. Sol. Energy Eng (November,2009)
Related Proceedings Papers
Related Chapters
A High Temperature Tubular Solar Receiver for Production of Hydrogen and Carbon Nanoparticles from Methane Cracking
Inaugural US-EU-China Thermophysics Conference-Renewable Energy 2009 (UECTC 2009 Proceedings)
Energy Balance for a Swimming Pool
Electromagnetic Waves and Heat Transfer: Sensitivites to Governing Variables in Everyday Life
Finite Element Solution of Natural Convection Flow of a Nanofluid along a Vertical Flat Plate with Streamwise Sinusoidal Surface Temperature
International Conference on Computer and Electrical Engineering 4th (ICCEE 2011)