This paper describes the stabilization method for small-bore circular journal bearings using starved lubrication. First, we describe the experimental examination to confirm the effect of supply oil conditions on stability of circular journal bearing by using a high-speed test rig. Then, the theoretical model considering the effect of amount of supply oil is discussed. Journal center trajectories are calculated by nonlinear motion analysis under various conditions. The theoretical results agree well with the experimental ones for three types of supply oil conditions and the mechanism of the stabilization by using the starved lubrication for small-bore journal bearings is clarified. Moreover, we suggest a supply oil control mechanism to stabilize the journal bearing using starved lubrication. Finally, the effectiveness of the proposed control mechanism on stability for high-speed small-bore journal bearings is verified experimentally.

1.
Pinkus
,
O.
, 1956, “
Analysis of Elliptical Bearings
,”
Trans. ASME
0097-6822,
78
, pp.
965
973
.
2.
Glienecke
,
J.
,
Han
,
D. C.
, and
Leonhard
,
M.
, 1980, “
Practical Determination & Use of Bearing Dynamic Coefficients
,”
Tribol. Int.
0301-679X,
13
(
6
), pp.
297
309
.
3.
Li
,
D. F.
,
Choy
,
K. C.
, and
Allaire
,
P. E.
, 1980, “
Stability & Transient Characteristics of Four Multilobe Journal Bearing Configurations
,”
ASME J. Lubr. Technol.
0022-2305,
102
, pp.
291
298
.
4.
Vaidyanathan
,
K.
, and
Keith
,
T. G.
, 1989, “
Numerica1 Prediction of Cavitation in Noncircular Journal Bearings
,”
STLE Tribol. Trans.
1040-2004,
32
(
2
), pp.
215
224
.
5.
Hashimoto
,
H.
, 1992, “
Dynamic Characteristics Analysis of Short Elliptical Journal Bearings in Turbulent Inertial Flow Regime
,”
STLE Tribol. Trans.
1040-2004,
35
(
4
), pp.
619
626
.
6.
Booser
,
E. R.
,
Missana
,
A.
, and
Ryan
,
F. D.
, 1970, “
Performance of Large Steam Turbine Journal Bearings
,”
ASLE Trans.
0569-8197,
13
, pp.
262
268
.
7.
Hashimoto
,
H.
, 1990, “
Dynamic Behavior of High-Speed Elliptical Journal Bearing (Part 1, Stability Analysis)
,”
Trans. Jpn. Soc. Mech. Eng., Ser. C
0387-5024,
56
(
529
), pp.
2483
2489
.
8.
Hashimoto
,
H.
, 1990, “
Dynamic Behavior of High-Speed Elliptical Journal Sliding Bearings (Part 2, Relationship Between Pressure Variation and Stability)
,”
Trans. Jpn. Soc. Mech. Eng., Ser. C
0387-5024,
56
(
529
), pp.
2490
2497
.
9.
Matsumoto
,
I.
,
Furukawa
,
T.
, and
Ezaki
,
Y.
, 1994, “
Study on Shafting Stability at Arbitrary Equilibrium Point of Multi-Lobe Bearing
,”
Trans. Jpn. Soc. Mech. Eng., Ser. C
0387-5024,
60
(
572
), pp.
1238
1243
.
10.
Hashimoto
,
H.
, and
Matsumoto
,
K.
, 2001, “
Improvement of Operating Characteristics of High-Speed Hydrodynamic Journal Bearings by Optimum Design: Part I—Formation of Methodology and Its Application to Elliptical Bearing Design
,”
Trans. ASME, J. Tribol.
0742-4787,
123
, pp.
305
312
.
11.
Matsumoto
,
K.
, and
Hashimoto
,
H.
, 2004, “
Study on Improvement of Stability of Noncircular Journal Bearing (Analysis of Stability in Case of Bearing Orientation Angle Change)
,”
Trans. Jpn. Soc. Mech. Eng., Ser. C
0387-5024,
70
(
692
), pp.
1199
1206
.
12.
Hashimoto
,
H.
, and
Ochiai
,
M.
, 2009, “
Experimental Study on the Stabilization of Small Bore Journal Bearings by Controlling Starved Lubrication and Bearing Orientation Angle
,”
Trans. ASME, J. Tribol.
0742-4787,
131
(
1
), p.
011705
.
13.
Vijayaraghavan
,
D.
, and
Keith
,
T. G.
, 1996, “
Effect of Lubricant Supply Starvation on the Thermohydrodynamic Performance of a Journal Bearing
,”
STLE Tribol. Trans.
1040-2004,
39
(
3
), pp.
645
653
.
14.
Tanaka
,
M.
, 2000, “
Journal Bearing Performance Under Starved Lubrication
,”
Tribol. Int.
0301-679X,
33
, pp.
259
264
.
You do not currently have access to this content.